How to use PJREQ as username for JVC projector

2014 · 2 replies · Configuration

This discussion is 12 years old. It predates today's Roomie Remote X, and the app names, menus, features, pricing, and device details below have changed substantially since 2014. Treat it as historical reference — see Support and current compatibility for how things work today.

In short

In the notes section of the IP compatibility for JVC, it says that PJREQ must be use as the username, but where it shoul — Staff replied: “This is a bit confusing right now pre-2.1. We deployed a new "IP" set that is designed for Roomie 2.1 and should not be used until then. There are two sets right now.”

Question 2014-02 · older version

In the notes section of the IP compatibility for JVC, it says that PJREQ must be use as the username, but where it should be used?

When I am creating the device, I do not see any field to enter the username.

Help will be appreciated.

Thanks in advance.

Roomie Staff 2014-02 · older version

This is a bit confusing right now pre-2.1. We deployed a new "IP" set that is designed for Roomie 2.1 and should not be used until then. There are two sets right now. Pre-Roomie 2.1 select "D-ILA Serial" for both Serial and IP control. With 2.1 or later, select IP or Serial as appropriate.

If anyone already set this up prior to a couple weeks ago when that set was deployed, no changes are required.

Thank you.

Member 2014-02 · older version

Thanks for your response.

I am using D-ILA Serial and now I can control the projector.

Regards.

 

← PreviousVersion 2.1 Imminent Release Next →Panasonic VT/ZT IP Input Commands

Related threads

Today's Roomie controls 400,000+ devices.

Roomie Remote X brings TVs, receivers, streamers, lights, and whole-home audio into one app on iPhone, iPad, Mac, and Apple TV.

Download Roomie Remote X